Erreka TAGBASE-250 Manual De Instrucciones página 7

TAGBASE
BASIC CONTROL BOARD
PLUG-IN RECEIVER BASE AND TAG CARDS AND KEYS DECODER
Connection with two wires
+12V L1+ –
TAGREAD
Connection with three wires
+12V L1+ –
TAGREAD
Components
F1 Circuit protection fuse (500mA)
B1 Programming buzzer
A beep (approx. 1 second): user key programming has been activated using the master key
A long beep (approx. 3 seconds): a key cannot be registered as the memory is full
Two short beeps: a key has been correctly programmed
Three short beeps: a master key has been correctly programmed
TAGMEMO Memory to store TAG card and key codes
RE Plug-in receiver with monochannel/bichannel decoder (not included)
L1 Reader 1 TAG cards and keys (not included)
L2 Reader 2 TAG cards and keys (not included)
ANT1 Antenna to improve radio reception (not included)
D1, D2 DIPs for programming TAG cards and keys
D1=OFF and D2=OFF: operation mode
D1=ON and D2=OFF: programming user keys
D1=OFF and D2=ON: programming first master key
D1=ON and D2=ON: programming second master key
DL1 Power supply (ON)
DL2 RUN/OK (reader signal)
LRL1 Relay RL1 activated
LRL2 Relay RL2 activated
-250
L2+
L2+
TAGMEMO
+12V L1+ – L2+
TAGREAD
English
P272A
7
TAGBASE