Product Instruction - SBS 3908 Manual De Instrucciones

PRODUCT AND WARNING INSTRUCTION – LEAFLET NO. L 3908
SBS BRAKE SYSTEM BLEEDER – ART. NO. 3908
BRAKE FLUID DRAINING – fig. no. 1-4
1) Connect the male adapter (A) to coupling/air chuck (B) on air
compressor hose. Minimum air pressure necessary: 6 BAR/
84PSI
3) Fit rubber pipe (A) on air bleeder nipple (B). Close locking
device (C). Loosen air bleeder nipple (D).
BRAKE FLUID REPLACEMENT – fig. no. 5-6
5) Fill SBS-201 "DOT 5.1 Non Silicone Base Brake Fluid"
or any other type of brake fluid recommended by the vehicle
manufacturer into the reservoir (A).

PRODUCT INSTRUCTION

2) Remove the reservoir cover (A) and the rubber cap (B) from
the bleed valve. Clean air bleeder nipple.
4) Activate handle (A). Open locking device (B). The brake fluid
will now be sucked into the brake system bleeder reservoir
(C). Empty system completely for old brake fluid.
6) Repeat step 4 (A) and (B) until new brake fluid comes out
into the plastic hose (C). Refill the brake fluid reservoir until
upper level line. Fasten bleeder nipple (D) and close locking
device.
GB
15