Getting Started; Changing The Color Code Ring; Attaching The Brush Head; Charging Your Sonicare - Philips sonicare FlexCare+ 900+ Serie Manual De Instrucciones

Ocultar thumbs Ver también para sonicare FlexCare+ 900+ Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

ENGLISH
6
4235.020.3356.1.indd 6
4235.020.3356.1.indd 6

Getting started

Changing the color code ring

Sonicare brush heads come with interchangeable color code rings to
identify your brush head.
To change the color code ring:
1
Pull the color code ring from the bottom of the brush head.
2
Install a new ring by slipping one edge of the new ring over the
bottom of the brush head.

Attaching the brush head

1
Align the brush head so the bristles face the front of the handle.
2
Firmly press the brush head down on the metal shaft until it stops.
Note: There is a small gap between the color code ring and the handle.

Charging your Sonicare

1
Put the plug of the charger in a live electrical outlet.
2
Place the handle on the charger.
The fl ashing light of the battery gauge indicates that the toothbrush
,
is charging.
-
1 solid green LED indicates that the toothbrush is 34-66% charged.
-
2 solid green LEDs indicate that the toothbrush is 67-94% charged.
-
3 solid green LEDs indicate that the toothbrush is fully charged.
Note: If the battery charge of your Sonicare is low, you hear 3 beeps and 1
LED of the recharge gauge fl ashes yellow for 30 seconds after completing the
brushing cycle.
06-04-09 09:32
06-04-09 09:32

Publicidad

Tabla de contenido
loading

Tabla de contenido