Unpacking And Cleaning - fireStorm FS210LS Manual De Instrucciones

Carefully unpack the machine and all loose items from the shipping container(s). Remove the protective coating from
all unpainted surfaces. This coating may be removed with a soft cloth moistened with kerosene (do not use acetone,
gasoline or lacquer thinner for this purpose). After cleaning, cover the unpainted surfaces with a good quality household
floor paste wax.
NOTICE: THE PHOTO ON THE MANUAL COVER ILLUSTRATES THE
CURRENT PRODUCTION MODEL. ALL OTHER ILLUSTRATIONS CONTAINED
IN THE MANUAL ARE REPRESENTATIVE ONLY AND MAY NOT DEPICT THE
ACTUAL COLOR, LABELING OR ACCESSORIES AND ARE INTENDED TO
ILLUSTRATE TECHNIQUE ONLY.
1). Adjustable wrench
2.) 13mm wrench for stand bolts.
3.) 10mm wrench for splitter assembly bolts, rear supports assembly and extension wings assembly.
4.) Slotted screwdriver.
6.) Phillips screwdriver.
5.) Straight edge and/or framing square for adjustments.
TABLE SAW PARTS
1- Saw
2- Left Extension Wing
3- 1/4 in.-20X1 in.Hex Head
Screw for Left Extension
Wing (3)
4- 1/4 in. Flat Washer for
Left Extension Wing (6)
5- 1/4 in. Lockwasher for
Left Extension Wing (3)
6- 1/4 in.-20 Hex Nut for Left
Extension Wing (3)
7- Right Extension Wing
8- 1/4 in.-20X5/8 in.Hex
Head Screw for Right
Extension Wing (3)
9- 1/4 in. Flat Washer for
Right Extension Wing (3)
10- 1/4 in. Lockwasher for
Right Extension Wing (3)

UNPACKING AND CLEANING

ASSEMBLY
ASSEMBLY TOOLS REQUIRED
ASSEMBLY TIME ESTIMATE
2 Hours
4 5
3
2
6
1
Fig. 1
7 7
9
10
8
7