Publicidad
Idiomas disponibles
Idiomas disponibles
1. Introduction & Features
Thank you for buying the CARDVDM! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't install or use it and contact your dealer.
The main features of the CARDVDM are:
• high reliability PLL synthesized tuning system
• 2 carrier frequencies
• well isolated from nonessential frequencies
• compact and light – can be placed behind the radio inside the dashboard
2. Safety Instructions
• Damage caused by user modifications or disregard of certain guidelines in this manual is not covered by the
warranty and the dealer will not accept responsibility for any ensuing defects or problems.
• Install the device where it is protected against extreme heat, dust and moisture.
• Make sure that the available voltage does not exceed the voltage stated in the specifications (12Vdc/30mA).
• The CARDVDM is fully transistorized and does not contain parts that can be repaired by the user. Do not open the
housing to avoid exposure to dangerous voltage. Servicing must be done by qualified personnel only.
3. Installation
Install the CARDVDM as described and shown below:
1. Connect the ground (#1) and 12V (#2) wires to your car battery.
2. Connect the audio outputs of the audio source (in this case: a DVD player) to the audio inputs of the CARDVDM.
3. Connect the car antenna (CAR ANT) input jack to the
car antenna and the radio antenna (RADIO ANT)
output jack to the antenna input jack of the car stereo.
4. Select the carrier frequency on the CARDVDM as
applicable for your car stereo system (88.3 / 88.7 MHz).
5. Install the device in a safe place inside your dashboard.
6. Make sure the device is switched off (#3) when you're
not using it.
4. Technical Specifications
Power Supply
Carrier frequency
Tuning system
Input terminals / impedance
Antenna connectors
The information in this manual is subject to change without prior notice.
CARDVDM
CARDVDM – CAR FM MODULATOR
1 = ground wire
2 = 12V wire
3 = switch
12Vdc / 30mA
88.3 MHz / 88.7 MHz
PLL synthesized
RCA jack left & right / 5K
RCA jack, coaxial
- 1 -
VELLEMAN
Publicidad
Tabla de contenido
Manuales relacionados para Velleman CARDVDM
Resumen de contenidos para Velleman CARDVDM
- Página 1 • Make sure that the available voltage does not exceed the voltage stated in the specifications (12Vdc/30mA). • The CARDVDM is fully transistorized and does not contain parts that can be repaired by the user. Do not open the housing to avoid exposure to dangerous voltage. Servicing must be done by qualified personnel only.
-
Página 2: Veiligheidsinstructies
1. Sluit de aardkabel (#1) en de 12V-kabel (#2) aan op de batterij van uw auto. 2. Sluit de audio-uitgangen van de audiobron (hier: een DVD-speler) aan op de audio-ingangen van de CARDVDM. 3. Sluit de antenne-ingang (CAR ANT) aan op de auto- antenne en de radioantenne-uitgang (RADIO ANT) op de antenne-ingang van de geluidsinstallatie van de auto. - Página 3 1. Connectez les fils de mise à la terre (#1) et 12V (#2) à l'accu de votre voiture. 2. Connectez les sorties audio de la source audio (dans ce cas: un lecteur DVD) aux entrées audio du CARDVDM. 3. Connectez l'entrée pour l'antenne de la voiture (CAR ANT) à l'antenne de la voiture et la sortie pour l'antenne de la radio (RADIO ANT) à...
-
Página 4: Instalación
• Asegúrese de que la tensión de red no sea mayor que la tensión indicada en las especificaciones (12Vcc / 30 mA). • El CARDVDM se controla completamente por transistor y no contiene partes reemplazables por el usuario. No abra la caja para evitar una exposición a tensiones peligrosas. El mantenimiento debe ser realizado por personal especializado. -
Página 5: Sicherheitsvorschriften
• Achten Sie darauf, dass die verfügbare Spannung die Spannung in der technischen Daten nicht überschreitet (12Vdc/30mA). • Der CARDVDM ist ganz transistoriert und enthält keine Teile, welche vom Benutzer repariert werden können. Das Gerät darf nur von Fachleuten gewartet werden.