Publicidad
Product
Instructions
Maintenance Instructions
Tool maintenance can effect the life of your Compact Angled
PEX Crimp Hand Tool and the quality of the tool's crimp.
Lubricate the pivot points frequently with light oil to ensure
smooth action and maximum tool life.
DO NOT ATTEMPT TO REPAIR THE TOOL. FOR TOOL
INFORMATION, CALL VIEGA, AT 800-976-9819.
1
3
5
This document subject to updates. For the most current Viega technical literature please visit www.viega.us.
Click Services -> Click Electronic Literature Downloads -> Select Product Line -> Select Desired Document
Viega LLC, 100 N. Broadway, 6
PI-PR 560629 0315 (HCC Crimp Tool) (EN ES FR)
2
4
6
Floor • Wichita, KS 67202 • Ph: 800-976-9819 • Fax: 316-425-7618
th
IMPORTANT: The Compact Angled PEX Crimp Hand Tool is
under limited warranty for twelve (12) months from date of
purchase. To ensure warranty availability, fill out the information
on the reverse side and retain with a dated proof of purchase.
Please include a copy of your proof of purchase when returning
your tool for any adjustment or repair covered under warranty.
Tool Adjustment Procedures
1. Note the number to which the line on the hex head of the
back pin points.
2. Carefully remove the retaining clip by inserting a small
flat blade screwdriver in the loop of the clip and turning
the screwdriver. CAUTION! The retaining clip is made
from spring steel and may fly off of the pin if not removed
carefully, possibly causing eye damage and loss of the clip.
3. From the clip end of the back pin, push it towards the tool
body until the hex head on the other end of the pin just
clears the body.
4. Rotate the pin until the line on the hex head points to the
next higher number on the frame.
5. Push the pin back into the frame and replace the retaining
clip.
6. Crimp a test joint and check crimp ring for proper sizing with
GO gauge or measurement. Severely worn tools may require
further adjustment. As the tool continues to wear with use,
simply repeat these instructions as required.
2 of 4
Publicidad
