Confirm Proper Operation; Operating Sequence - Kohler K-702 Guia De Instalacion

Bañera de hidromasaje de sobreponer
Ocultar thumbs Ver también para K-702:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Heater
Heater Indicator Light
On/Off
Increases Flow
Power
Decreases Flow
On/Off
Lighted User Keypad
(for whirlpools without neckjets)
14. Confirm Proper Operation
Fill the Whirlpool
NOTE: Please read these steps carefully before you operate your whirlpool.
Position the jet nozzles so they face down toward the basin. Turn the jet trim rings fully
counterclockwise.
Fill the whirlpool to a water level at least 2" (5.1 cm) above the top of the highest jet.
NOTE: The water temperature in the whirlpool should not exceed 104°F (40°C). The heater will
automatically turn off as the water temperature approaches 104°F (40°C) and will remain off until the
water cools.

15. Operating Sequence

Models without Neckjets
NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is
running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at
higher temperatures.
IMPORTANT! Please refer to your Homeowners Guide for detailed instructions on the user keypad and
optional remote control.
Press the Power On/Off button to turn on the whirlpool. The whirlpool will start at medium flow.
Increase or decrease the water flow by pressing either the up or down arrow buttons on the keypad.
An indicator bar in the center of the keypad shows the water flow volume.
Adjust each jet for optimum air/water mixture. Turn the jet trim clockwise to reduce the air flow,
and counterclockwise to increase the air flow.
Press the heater button to turn the heater off and back on. When illuminated, the indicator light
shows that the water temperature will be maintained up to 104°F (40°C).
Press the Power On/Off button a second time to turn the whirlpool off.
NOTE: A built-in timer automatically stops the pump and motor after approximately 20 minutes of
operation.
Models with Neckjets
NOTE: A built-in heater automatically helps to maintain the water temperature when the whirlpool is
running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at
higher temperatures.
1018963-2-F
Activates Mode
Selected
Flow Mode
Indicator Bar - Shows
water flow volume
Power On/Off
Lighted User Keypad
(for whirlpools with neckjets)
Increases Flow
Neckjet Mode -
Adjust Pulse
Decreases Flow
Heater On/Off
12
Turn the jet trim
clockwise to
decrease the flow.
Turn the jet trim
counterclockwise to
increase the flow.
Kohler Co.

Publicidad

Tabla de contenido
loading

Tabla de contenido