Publicidad
Model: 14319 / ZW4003
ADVANCED OPERATION
The following Advanced Operation parameters require that you have a controller that supports the advanced
configuration command class.
All On/All Off
Depending upon your primary controller, this Z-Wave module can be set to respond to ALL ON and ALL OFF
commands in up to four different ways. Some controllers may not be able to change the response from its default
setting. Please refer to your controller's instructions for information on whether or not it supports the configuration
function and if so, how to change this setting.
The four possible responses are:
1. It will respond to ALL ON and the ALL OFF commands (default).
2. It will not respond to ALL ON or ALL OFF commands.
3. It will respond to the ALL OFF command but will not respond to the ALL ON command.
4. It will respond to the ALL ON command but will not respond to the ALL OFF command.
Invert Switch
If the switch is accidentally installed upside down with "On" at the bottom and "Off" at the top, the default On/Off
rocker settings can be reversed by changing parameter 4's value to "1".
• Parameter No: 4
• Length: 1 Byte
• Valid Values = 0 or 1 (default 0)
Publicidad
