Programming Rat Controller; 5.1. Information Shown On Display; 5.2. Profiler States; 5.3. Main Menu - Selecta DQO 6 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80158 REV D
The RAT temperature profiler perform
"profiles" as a sequence of "steps"
defined with time and temperature.
Overtemperature
Display
alarm
Validate Up
Menu Down
"ON"
S ºC MIN PR STA
1 145 31 1 STP
+ 5 sec.
S ºC MIN PR STA
1 145 31 1 PRG
+ 5 sec.
SELECTION
Celsius
Use to set Celsius o
Fahrenheit temperature units.
J
.P. SELECTA s.a.u.
5. Programming temperature profiler

5.1. Information shown on display

Step
S ºC
1 145
Temperature
5.2. Profiler states
There are four possible states of the RAT controller.
• STP: "Stop" which is the default state, waiting for the user to select a
temperature profile to execute or modify.
• RUN: The controller executes a temperature profile.
• PRG: Menu for programming a temperature profile.
• CFG: Configuration options, units and calibration.
Note: State: PRG and CFG, the controller returns to the state STP if no key is
pressed for more than 10s.
Note: Once the program running is stopped by pressing the R / S key.
RUN/
STOP

5.3. Main menu

S ºC
R/S
1 145
Cursor
Programming menu
Validate
STA CALIBRATE
CFG 00ºC
Use
for temperature calibration if
necessary.
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
OCT/2019 (It can be modified without notice)
Status
(Start or
Time
stop)
MIN PR STA
31 1 STP
Profile
MIN PR STA
31 1 RUN
Validate
STA
CFG
to set an offset value
PARAMETER NAME
PARAMETER VALUE
Note: Pay attention where the
cursor is located.
Starts profile.
IDIOMA
English
Use for interface language
set.
Tel 34 93 770 08 77 Fax 34 93 770 23 62
Page: 25
Validate
STA
STP