Craftsman CMCST960 Manual De Instrucciones página 9

An extended coverage guard is available (sold separately)
for extra coverage if desired. Use CRAFTSMAN replacement
guard Part Number N640544.
Fig. B
5
Assembling the Pole (Fig. C–E)
1. Do not remove the zip tie until the pole is assembled.
2. Ensure that the sleeve
pole 6 is fully extended.
nOTE: To adjust the sleeve, release the sleeve latch
move the sleeve into position.
3. Lock the sleeve latch.
4. With the sleeve latch closed, slide the upper trimmer
pole into the sleeve lower trimmer pole. The latching
button will click into position when it engages the
17
latch hole.
5. Tighten the top screw 18
17 18
Fig. C
Fig. D
14
8
on the lower trimmer
14
15
with a crosshead screwdriver.
14
Fig. E
17
Adjusting the Auxiliary Handle (Fig. F)
The auxiliary handle
However, if adjustment is necessary, release the auxiliary
handle latch 19 . and slide the handle up or down the upper
trimmer pole until it is in the desired location. Close the
auxiliary handle latch to lock the handle in place.
Fig. F
and
15
6
OPERATION
WARNING:

serious personal injury, turn unit off and
remove the battery pack before making any
adjustments or removing/installing attachments
or accessories, when replacing line, or prior to
cleaning. An accidental start-up can cause injury.

WARNING:
protection that conforms to ANSI Z87.1 (CAN/CSA
Z94.3) while operating this appliance.

CAUTION:
use the appropriate type of cutting line.
18
15
4 is positioned to maximize balance.
4
To reduce the risk of
Always use proper eye
Before you begin trimming, only
English
19
7