Troubleshooting - Klarstein 10031909 Manual Del Usuario

Replacing the Filter
Dissamble filter
1 Hold the top of the front panel, pull
the panel out to a 45-degree angle,
then lift up the panel.
2 Pull and hold the two braces on
both sides of the filterby, then pull it
slightly to disassemble it.

TROUBLESHOOTING

Problem Possible reasons
The unit is not Power cord is not plugged/
working. power has no electricity.
Power switch is off.
The purification End of service life.
effect is poor.
Air inlet/outlet is blocked .
Wrong installation of the filter
direction.
The air volume is The filter is too dirty.
small.
Please make sure all the package is removed.
Assemble filter
3 Align the filter to the slot, the side
with braces outward, then push into
the unit slightly.
4 Insert the bottom buckle to the holes
in the front cover, then assemble the
front panel into the cover slightly.
Solutions
Plug in the power supply/
Ensure the power supply is
working.
Press "on/off" button.
Change the filter.
Clean foreign parts of air
inlet/outlet.
Install filter in the right way.
Change or clean the filter.
EN
15