Edge Cleaner; Suction Control; Overload Protector - Kenmore 116.23612 Manual Del Propietário

iiiiiiiiii!iiiiiiiiiiiiiiiiiiiiiiiiiii7iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii ! ii i i !! i i !ii ! i i iii iiiiiiiiiiiiii iiiiiiiiiii
ATTACHMENT
Dusting brush I_
Crevice tool
Fabric brush
Floor brush
Power-Mate®
Handi-Mate Jr.*_
(Some Models)'*" I_
Power-Mate Jr._"
ISome Modelsr**
Furn{ture*
x
x
x
x
x
Between
Cushions"
X
CLEANING AREA
Bare
Drapes' Stairs Floors
x
x
x x
x**
x
x
Carpeted
FIoors/Rug=
X
Wafts
X
x
"Alwaysclean attachments beforeusing on fabrics. ** 3-way On/Off switchshould be in FLOOR position
*** Handi-Mate Jr.._ and Power-Mate Jr." attachment instructions are included with the products,
NOTE: When separating wands, depress lock button completely before pullingwands apart. If
wand lock button is difficult to eepress push the two wanes more tightly together to line up
the ock button w th the hole. Depress lock button and then pull wands apart.
EDGE CLEANER
Active brush edge
cleaners are on both
sides of the Power-
Mater Guide either
side of the Power-
Mate *_along base-
boards or next to
furniture to help
remove dirt trapped at
carpet edges.
OVERLOAD PROTECTOR
The Power-Mate * has
built-in protection
against motor and
belt damage should
the agitator jam. If the
agitator slows down
or stops, the overload
protector shuts off the
Power-Mate ®. The
Overload Protector
canister motor will continue to run.
To correct problem: Turn off vacuum,
remove obstruction, then press reset button.
To reset: Press the overload protector
button. A ball point pen may be required.
SUCTION CONTROL
The suction
control allows
you to change
the vacuum
suction for
different fabrics suction
and carpet
weights. Opening the control decreases
suction for draperies and lightweight rugs,
while closing the control increases suction
for upholsteries and carpets.
Suction
11