Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
TO REPLACE BELT
1. Install new
belt over motor
drive, then
over brush
sprocket.
NOTE: See
PARTS AND
FEATURES
for belt num-
ber.
End Cap
Motor
Brush
Drive
Sprocket
2. Place agitator
assembly
back
into Power-Mate ® .
Cover
Base
4. Rotate
cover
back.
Press cover
firmly until side
and rear tabs
snap into
place. Turn
Power-Mate ®
upside down
and replace
two (2) cover screws.
3. Line up
front of
cover and
base.
Rest
cover on
frontedge
of base as
shown.
1. Remove Power-Mate ® cover as shown in
BELT CHANGING
AND AGITATOR
CLEAN-
ING section.
Push In
,_
And Turn
2. Push in and turn
bulb counterclock-
wise. then pull out
to remove.
Push In
And Turn
3. Push in and turn
bulb clockwise,
to
replace.
Bulb must
not be higher than
15 Watts(130
Volts).
4. Reinstall
Power-Mate ® cover as shown in
BELT CHANGING
AND AGITATOR CLEAN-
ING section.
NOTE: See PARTS AND FEATURES
for
bulb number.
17
Publicidad
Tabla de contenido
