Safety Notes; Important Notes; Functions; Information About Operation - LGB 2091 Manual De Usario

Safety Notes

• This model may only be used with an operating system designed for it.
• Use only switched mode power packs and transformers that are designed for your
local household current.
• This model may only receive power from one source at a time.
• Make sure that you read the safety notes in the instructions for your operating
system.
• Not for children under the age of 15.
• IMPORTANT! This model has sharp edges and points due to the design of its
working functions.

Important Notes

• The operating instructions are a component part of this product and must there-
fore be kept in a safe place as well as be included with the product when the latter
is given to a third party.
• Please see your authorized LGB specialty dealer for repairs or spare parts.
• The warranty card included with this product specifies the warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
Working Features
• This model is designed for operation on LGB 2-rail DC systems with conventional
LGB DC locomotive controllers (DC, 0 - 24 volts).
• Use a locomotive controller with more than 1 amp of operating current for this
model.
• The 65006 diesel locomotive sound kit can be added to this locomotive. Complete
installation instructions are included with this kit.
Mode of Operation Switch
This locomotive has a 4-position mode of operation switch (Figure 1).
Pos. 0 Locomotive stopped and stored without current
Pos. 1 Lighting turned on
Pos. 2 Locomotive motors and lighting turned on
Pos. 3 Same as Position 2
General-Purpose Socket
This model has a general-purpose socket for flat plugs on the rear of the locomotive
(Figure 2). LGB cars with lighting or sound effects circuits can be connected to the
track voltage by means of this socket.
Multi-Train System
This model comes from the factory with a decoder installed for the LGB multi-train
system. It can be used without changes on conventional analog layouts or with the
digital multi-train system. The model is programmed for locomotive address 03 for use
with the LGB multi-train system.
Information about programming the locomotive address can be found in the instruc-
tions for the different MTS controllers.
Locomotive functions can be controlled remotely when operating with the multi-train
system. The locomotive's lighting is turned on and off by means of the lighting button
(„9" on the hand controllers).
The locomotive has a load compensation feature when it is operated with the multi-
train system: The motor rpm (and thereby the speed under normal conditions) is held
constant, even when the locomotive's load changes, such as on curves or grades.
MAINTENANCE
Lubrication
Oil each of the axle bearings now and then with a drop of LGB oil (item no. 50019).
Replacing Light Bulbs (E130023)
Lamps (lower): Pull the lamp housing from the model. Pull the light bulb from the
socket. Insert the new light bulb. Put the model back together.
Interior Lighting: Loosen four screws at the corners of the cab roof and remove the
cab roof. Pull the light bulb from the socket. Insert the new light bulb. Put the model
back together.
Replacing Traction Tires (E126174)
• Use a small flat blade screwdriver to remove the old traction tire:
• Lift the old traction tire from the groove in the driving wheel.
• Carefully push the new traction tire over the wheel and into the groove.
• Make sure that the traction tire is properly seated.
6