Start-Up And Operation - Waldbeck Lakeside Powerplus 10033423 Manual Del Usuario

START-UP AND OPERATION

• Please read the operating instruction thoroughly.
• Remove all accessories and packages from the vessel.
• Check before and after use that the switch is in position (0) OFF.
• Always use the device with the filter insert suitable for the relevant
application.
Using the device for pond and pool vacuuming
• Position the device at a safety clearance of 2 m away from the pond.
• Place the drain hose (3) in such a way that the water can easily flow either
back into the pond or to a suitable location in the garden.
• Open the two locking clips on the side and pull the filter sponge motor (13)
with the cord upwards above the motor protective grid. Tighten and lock
the cord for tight seat. After this, return the motor and close the two clips.
• Connect the plug-in connector of the suction hose (9) with the bayonet
catch at the top of the container and lock the connection by a half turn to
the right.
• Assemble the suction nozzle (12) and the relevant number of suction tube
extensions for the application with the suction tube connection and, after
this, turn the switch (2) to II AUTOMATIC to switch on the device.
• After a working interval of approximately 30 seconds, the device switches
off for approximately 30 seconds in order to empty the filled collecting
vessel. During this time, you can look for the following location to be
cleaned and place the vacuuming device accordingly.
• The device operates now continuously after this time interval.
• Coarse dirt will be collected in the dirt collecting bag (4), which you can
attach to the end of the drain hose (3). Depending on the degree of dirt,
the dirt collecting bag (4) should be cleaned regularly; preferably at the
end of each application.
• It is up to you to decide if the water, filtered with the dirt collecting bag,
should be returned to the pond or drained into the garden.
• If you want to interrupt or finish your work, turn the switch again into
position (0) OFF. Always pull out the plug, if the device is not used.
• Dirt and water should be thoroughly removed from the inside of the
collecting vessel after the end of each application.
EN
15