Cleaning And Care - Waldbeck Lakeside Powerplus 10033423 Manual Del Usuario

EN
16
Using the device for wet and dry vacuuming
• Fit the blanking plug (5) at the outlet of the collecting vessel.
• For wet vacuuming: Fasten the filter sponge for the motor (13) (see pond
and pool vacuuming device).
• For dry vacuuming: Fasten the paper filter bag (15) to the inside of the
upper opening of the collecting vessel.
• For switching on the device, turn the switch (2) to I, MANUAL. In this
position, the device operates continuously in continuous operation
without interval switching.
• Check the filling level of the collecting vessel from time to time and, if
necessary, empty or replace it.
• Switch off the device after use (0), pull out the net plug and clean collecting
vessel as well as filter inserts.
Switching/Operating Modes
Switch position 0 Motor off
Switch position I Manual operation (ON/OFF) for wet/dry vacuuming operation
Switch position II Automatic operation for pond and pool cleaning
• After switching on, the motor will suck for 30 seconds.
• b) Motor stops after approximately 30 seconds to drain.
• Auto Start after 30 seconds.
• Repetition (a) and (b) to OFF (0).

CLEANING AND CARE

• Thoroughly clean the collecting vessel and dirt collecting bag (4) with
water and, possibly, with a little mild household cleaner.
• Check suction hose (9), suction tubes and drain hose (3) occasionally for
possible blocking or dirt residues and remove them.
• Carefully wash the filter sponge for the motor (13) with water and.
possibly, with a mild household cleaner and dry it afterwards.