Descargar Imprimir esta página

Helvex Vertika 16104 Guia De Instalacion página 2

Publicidad

Inserte los taquetes (incluidos) y fije el ancla con la pijas (incluidas).
5
the wall bracket with lags screws (included).
Nota: Se debe de insertar completamente el taquete.
No rebajar ni cortar el taquete.
Note: The anchors must be inserted completely.
Do not cut the anchors.
Enrosque el opresor, nivele y finalmente
7
apriete el opresor hasta fijar el accesorio.
Screw on the set screw, level and finally
tighten the set screw until fixture is secured.
nivel
level
opresor
set screw
Participa en nuestros
cursos gratuitos
de capacitación.
Enter our free
training courses.
Recomendaciones de Limpieza / Cleaning Recommendations
Es muy importante seguir las siguientes instrucciones para conservar los
acabados de los productos HELVEX, con brillo y en perfecto estado:
1. Utilice únicamente agua y un paño limpio.
2. No utilice fibras, polvos, abrasivos, ni productos químicos.
3. No utilice objetos punzo-cortantes para limpiar los acabados.
4. Se recomienda realizar la limpieza de su producto diariamente.
Visite nuestras páginas www.helvex.com.mx para México y www.helvex.com
para el mercado Internacional
HELVEX, S. A. DE C. V. Calzada Coltongo # 293, Col. Industrial Vallejo, Alcaldía Azcapotzalco, C. P. 02300, Ciudad de México.
/ Insert anchors (included) and set
taquete
anchors
/
Siga los pasos del 1 al 7 respetando la
8
siguiente dimensión.
according to the following dimension.
Comunícate:
Contact:
En la Ciudad de México:
In Mexico City:
(52) 55 53 33 94 00
Ext. 5806, 5805 y 5804
pija
lag screw
9
/ Follow steps 1 to 7
En Monterrey:
En Guadalajara:
In Monterrey:
In Guadalajara:
81 83 33 57 67
33 36 19 01 13
81 83 33 61 78
It is very important to follow the instructions below to preserve HELVEX products
finishes, shiny and in perfect condition:
1. Use only water and a clean cloth.
2. Do not use fibers, powders, abrasives, or chemicals.
3. Do not use sharp objects to clean the finish.
4. It is recommended to clean your product daily.
Visit our pages www.helvex.com.mx for Mexico and www.helvex.com
for the International market.
Coloque el accesorio en el ancla.
6
Attach accessory at wall bracket.
Asegúrese de nivelar y apretar el opresor para
fijar el accesorio.
Be sure to level and tighten
the set screw to fixing the accessory.
nivel
level
/
opresor
set screw

Publicidad

loading

Este manual también es adecuado para:

Vertika 16105Vertika 16106Vertika 16107Vertika 16108Vertika 16109