Metra MZTO-01 Instrucciones De Instalación

MZTO-01
applIcatIons
maZda
CX-7
CX-9
KIt features
• Provides accessory (12-volt 10-amp)
• Used in amplified models
• Provides NAV outputs (parking brake, reverse, mute, and V.S.S.)
• Prewired ASWC-1 harness included (ASWC-1 sold separately)
• Adjustable gain control for overall volume
• High level speaker input
• Micro "B" USB updatable
• Retains balance and fade
Interface components
• MZTO interface • 16-pin harness with stripped leads
• 10 to 24-pin "T" harness
tools requIred
• Cutting tool • Tape • Crimping tool
• Connectors (i.e. butt-connectors, bell caps, etc.)
METRA. The World's best kits.
Installation Instructions for MZTO-01
2007-up
2007-up
™ 1-800-221-0932
Caution: Metra recommends disconnecting the negative battery terminal before
beginning any installation. All accessories, switches, and especially air bag indicator
lights must be plugged in before reconnecting the battery or cycling the ignition.
*Note: Refer also to the instructions included with the aftermarket radio.
connectIons to be made
(to the aftermarket radio)
from the 16-pin harness:
• The red wires will not be used in this application.
• The orange/White wire will not be used in this application.
• Connect the White wire to the left front positive speaker output.
• Connect the White/black wire to the left front negative speaker output.
• Connect the Gray wire to the right front positive speaker output.
• Connect the Gray/black wire to the right front negative speaker output.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/black wire to the radio's left rear negative speaker output.
• Connect the purple wire to the radio's right rear positive speaker output.
• Connect the purple/black wire to the radio's right rear negative speaker output.
• Connect the blue/White wire to the radio's amp turn on wire.
• The brown wire will not be used in this application.
• Connect the light Green wire to the parking brake wire (if required).
• Connect the blue/pink wire to the VSS or speed sense wire (if required).
• Connect the Green/purple wire to the reverse wire (if required).
from the 24-pin "t" harness:
• Connect the black wire to the ground wire.
• Connect the red wire to the ignition wire.
• Connect the Yellow wire to the radio's 12-volt battery or memory wire.
metraonline.com
(continued on next page)
© COPYRIGHT 2004-2011 METRA ELECTRONICS CORPORATION