Elko EP PSB-10-12 Manual Del Usuario página 3

ELKO EP, s.r.o.
Palackého 493
769 01 Holešov, Všetuly
Czech Republic
Tel.: +420 573 514 211
e-mail: elko@elkoep.com
www.elkoep.com
Made in Czech Republic
02-222/2016 Rev.: 2
Characteristics
• PSB-10: switching stabilized power supplies with fi xed output voltage, for mounting into an installation box
PSB-10-12: stabilized power supply 12 V / 10 W
PSB-10-24: stabilized power supply 24 V / 10 W
• PS-10: switching stabilized power supplies with fi xed output voltage, version 1-MODULE
PS-10-12: stabilized power supply 12 V / 10 W
PS-10-24: stabilized power supply 24 V / 10 W
• PS-30: switching stabilized power supplies, version 3-MODULE
PS-30-12: stabilized power supply with fi xed output voltage 12 V / 30 W
PS-30-24: stabilized power supply with fi xed output voltage 24 V / 30 W
PS-30-R: stabilized regulated power supply 12 - 24 V / 30 W
• PS-100: stabilized power supply with fi xed output voltage, version 6-MODULE
PS-100-12: stabilized power supply 12 V / 100 W
PS-100-24: stabilized power supply 24 V / 100 W
• output current is limited by electronic fuse, in case maximal current is exceeded, the device switches off and after a shot time interval it again switches on
• indication of output voltage by green LED on front panel (except PSB-10)
• temperature protection - if temperature is exceeded, the device switches off and after cooled down, it switches on again
Description
PS-10-12
1
2
PS-100-12
1
Connection
AC 110 - 250 V AC 230 V
50 Hz / 60 Hz 50 Hz / 60 Hz
N L N
AC AC
DC
-
+ +
DC 12 V / 0.84 A DC 12 V / 0.84 A
(DC 24 V / 0.42 A) (DC 24 V / 0.42 A)
PS-30-12
1
2
2
AC 100 - 250 V
50 Hz / 60 Hz
L N L
AC
DC DC
- -
+
DC 12 V / 2.5 A
(DC 24 V / 1.25 A)
PS-30-R
1
2
3
PSB-10-12
6 4
7 5
AC 100 - 250 V AC 230 V
50 Hz / 60 Hz 50 Hz / 60 Hz
N
N L
AC
AC
DC DC
-
+ +
DC 12 V - 24 V / DC 12 V / 8.4 A
2.5 - 1.25 A (DC 24 V / 4.2 A)
PS
Switching power supply PS
1. Supply terminals
2. Output voltage indication
3. Setting output voltage (only PS-R)
4. Output voltage (-)
5. Output voltage (+)
6. Neutral wire
7. Phase
Output voltage terminals
Output voltage terminals
Power supplies PS-xxx are overcurrent
protection devices, because it turns power
L
supplies off , if the output current exceeds
more than 20 % of the rated output of the
power supply. Therefore, these units are
not intended to supply e.g. halogen lamps,
because the starting / inrush current (in the
cold state) is approximately ten times the
amount of the steady-state operating current.
So these power supplies cannot turn on such
lamps.
-
EN
1 / 2