Beam Shaping; Operation; Strobe; Dim - Leviton LEO Guia Del Usuario

BEAM SHAPING

The LED Follow Spot light can be shaped as follows:
• Drop-in Iris Pattern
• Drop-in Gobo Pattern
• Variable Beam*
* Variable beam is altered by adjusting the front and rear zoom lenses in relation to one another.
The front lens defines the beam spread. The rear lens controls the softness or hardness of the beam edge.
Insert Iris or
Gobo Holder

OPERATION

For standard operation, connect the LEO™ LED Follow Spot to a power source (100-240VAC single phase). To switch ON,
press the POWER button at the back of the fixture. The red status indication lamp ( POWER ) on the control panel will light up
when power is applied.
NOTE: The fixture is equipped with two fans to aid in the cooling process. They are designed to vary their velocity at different
operating temperatures. Ensure vents are clean to maintain proper cooling. Avoid touching the fixture's housing as it may
become hot during use.
CONTROL INTERFACE (located on side of fixture)
PRESS
STROBE LIGHT EFFECT

STROBE

• To begin, press and hold the STROBE button.
• Release the STROBE button to stop the effect.
Light output will be resumed to the previous setting.
Iris Slot Gobo Slot
TO DIM
• To decrease light output, turn the dimming knob
counterclockwise to DIM.
• To increase light output, turn the dimming knob
clockwise to BRIGHT. The green status indication
lamp (DIM) on the control panel will light up
according to the intensity of the light output.
5
Front Lens
BRIGHT

DIM

Rear Lens