Cub Cadet 700 Serie Manual De Operación página 16

5. Remove the idler pulley bracket by removing the 5⁄16-24 hex
screw, flat washer and lock washer, as in "Figure 7-4".
Remove the
belt from the
idler pulley
by working it
under the belt
keepers.
NOTE: It will be necessary to remove the belt from around
the idler pulley by working it off the pulley and from
underneath each belt keeper.
6. Remove the flange nut securing the transmission drive
pulley, then remove the pulley along with the two belts.
See "Figure 7-5".
V-side out
Flange Nut
7. Replace the old belts with the new belts in the same order
they were removed. The longer belt (954-04091) belongs
closer to the engine (V-side out), with the shorter belt
(954-05069) positioned closer to the tines.
16 S 7— S
ection ervice
Remove the
idler pulley
bracket by
removing the
hex screw,
flat and lock
washers
Figure 7-4
Remove pulley
with belts
Figure 7-5
8. Reinstall the transmission drive pulley with the new belts.
9. Reassemble the tiller in the reverse order in which it was
disassembled.
NOTE: When reinstalling the belt cover, be sure to engage the
bail and hold it so that the drive belt is tight before attempting
to reinstall the belt cover. This will enable the belt to fall under
the belt keeping mechanism built into the belt cover. Failure
to do so could damage the belt and/or belt cover.
Tines
The tines will wear with use and should be inspected at the
beginning of each tilling season and after every 30 operating
hours. The tines can be replaced. Refer to the Illustrated Parts List
manual for part numbers and ordering instructions.
Tine Inspection
With use, the tines will become shorter, narrower and pointed.
Badly worn tines will result in a loss of tilling depth, and reduced
effectiveness when chopping up and turning under organic matter.
Removing/Installing a Tine Assembly & Tines
1. Remove the tine shield by removing the hex lock screw and
flat washers secruing it to the transmission on each side.
2. A tine assembly consists of a tine bracket and three tines.
There are two tine assemblies on the tiller a RH assembly
(Part No. 642-05032) and a LH assembly (642-05033).
NOTE: Marking the tines and taking note of the different
RH and LH assemblies will make re-installing the
assemblies properly easier.
3. To remove a tine assembly, simply remove the hex screw
and flange lock nut as seen in "Figure 7-6". Remove the hex
screw and slide the assembly off the tine shaft.
Figure 7-6
4. Before reinstalling the tine assembly, inspect the tine
shaft for rust, rough spots or burrs. Lightly file or sand, as
needed. Apply a thin coat of grease to the shaft.