Safety Information - Iso-Tech ICM 134 Instrucciones De Operación

Safety Information

Read and understand this Instruction
Manual completely before using this
instrument. Failure to observe the warnings
and cautions in this Instruction Manual may
result in injury or death, or damage to the
instrument and other equipment or
property.
If this instrument is used in a manner not
specified in these instructions, the protec-
tion provided by the instrument may be
impaired.
WARNING
- Examine the instrument and probes and
leads before use. Do not use the instru-
ment if it is wet or damaged, or if you
suspect it is not operating correctly.
- When using the instrument, test leads or
probes, keep your fingers behind the
finger guards.
- Remove the test lead from the instrument
before opening the battery cover or instru-
ment case.
- Always use the correct terminals, switch
position and range for measurements.
- Verify the instrument is operating correctly
by measuring a known voltage before
use. If in doubt, have the instrument
serviced.
- Do not apply more than the rated voltage
as marked on the instrument between
terminals, or between any terminal and
earth ground.
- Use caution when measuring voltages
above 30 Vac rms or 60 Vdc. These
voltages pose a shock hazard.
- To avoid incorrect readings that can lead
to electric shock, replace the battery as
soon as low battery indicator  appears
in the display.
- Disconnect the circuit power and
discharge all high-voltage capacitors
before making resistance, continuity, or
diode measurements.
- Do not use the instrument in a Hazardous
Area or around explosive gasses or
vapours.
EN - 2