Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5.
Release the control knob. If the pilot does not stay lit,
repeat Step 4. If the pilot stays lit, turn the control knob
counterclockwise to the desire heat setting.
6.
IMPORTANT: DO NOT attempt to adjust the main
burner input using the main gas supply valve, as this
may cause the thermocouple to shut down the burner.
Shut-down instructions:
To turn the heater Off:
1.
Turn the control knob clockwise to the "Off" position.
2.
Turn off the propane tank by turning the tank valve knob
clockwise until it stops.
3.
If the heater is not going to be used for an extend period
of time disconnect the regulator/hose assembly from the
propane tank.
MAINTENANCE INSTRUCTIONS
This heater (including hose and regulator assembly) must be
inspected before each use. If the hose for Model MH18CH shows
evidence of excessive abrasion or wear, or if the hose is cut, it
must be replaced prior to the heater being put into operation.
The replacement hose assembly shall be that specified by the
manufacturer. See the parts list.
The appliance area must be kept free and clear of combustible
materials, gasoline and other flammable vapors and liquids at all
times.
The flow of combustion and ventilation air must not be
obstructed.
Cleaning the heater:
Periodically, the heater must be cleaned of all dirt and dust
particles.
DANGER
DO NOT ATTEMPT TO CLEAN THE HEATER
WHILE IT IS OPERATING OR WHILE IT IS
STILL HOT.
•
Turn the heater off and wait until it has completely cooled (at
least 20 minutes) before cleaning.
•
Clean the outside of the heater using a damp cloth. DO NOT
clean the heater by spraying water on it. Wipe the outside of
the heater off with a dry cloth after cleaning.
•
Clean the inside of the heater using compressed air. Using
an OSHA appoved blow gun, blow compressed air back and
forth along the entire burner face to dislodge dust and debris
from the ceramic tiles. Using an OSHA appoved blow gun,
blow compressed air through venturi from the control end of
the heater.
•
Clean the orifice of each burner with a #68 drill bit
(for LP-Gas).
•
Clean the thermocouple lead.
E5
Portable Propane Cabinet Heater
DO NOT operate this heater if any part has been under
water. Call a qualified service person to inspect the appliance
and to replace any part of the control system or gas control valve
which has been under water.
This heater must be inspected at least annually by a qualified
service person.
TROUBLESHOOTING INFORMATION:
(Model MH18CH)
If burner lights, but goes out when button is released.
CHECK
•
Loose wires on tipover switch.
•
Loose lead wire at control valve and ODS/Pilot
Assembly.
•
Loose thermocouple and tighten if necessary.
•
Defective ODS/Pilot Assembly. Replace if necessary.
•
Defective control. Replace if necessary.
•
Defective tip over switch. Replace if necessary.
Figure 1
Operating Instructions and Owner's Manual
Publicidad
Capítulos
Tabla de contenido
