Safety Instructions - cecotec READY WARM 3500 CURVED FLAMES Manual De Instrucciones

1. SAFETY INSTRUCTIONS

Read these instructions thoroughly before using the appliance.
Keep this instruction manual for future reference or new users.
• Make sure that the mains voltage matches the voltage
stated on the rating label of the appliance and that the wall
outlet is grounded.
• This appliance is intended for household use only. Do not
use for industrial or commercial purposes. Not suitable for
outdoor use.
• Check the power cord regularly for visible damage. If the
cord is damaged, it must be replaced by the official Technical
Support Service of Cecotec in order to avoid any type of
danger.
• Furniture, curtains or flammable materials should be atleast
1 m away from the device.
• Do not place the powercord in front of the fireplace.
• Do not place the appliance close to heat sources, flammable
substances, wet surfaces where it can fall or be pushed into
water or allow it to come into contact with water or other
liquids.
• Do not place the appliance immediately below a power
socket.
• Always unplug the device when not in use.
• To disconnect the device, first turn all controls off, then
remove the plug from the power supply. Pull from the plug,
not the cord.
• Ensure the walls where the device is going to be installed
present no damage and that they are in good and safe
conditions.
• The fireplace must be used under an AC voltage rating.
• The product must be connected to the ground.
• Warning: This heater is not equipped with a device to control
the room temperature. Do not use this heater in small rooms
READY WARM 3500 CURVED FLAMES
ENGLISH
7