Installation Instructions - Premium PWDC202FM Manual De Uso Y Cuidado

INSTALLATION INSTRUCTIONS

REMOVE TRANSPORT BOLTS
Before using this washing machine, transport bolts must
be removed from its backside. Take the following steps
to remove the bolts:
1. Loosen all bolts with a wrench and then remove.
2. Cover the holes with included transport hole plugs.
3. Store the transport bolts properly for future use.
Transport Bolts (4)
CONNECT INLET PIPE
Connect the inlet pipe as indicated in Figure 7.
For models with a hot valve, connect the hot valve to
hot water tap.
INSTALL INLET PIPE
1. Connect the elbow to the tap and fasten it
clockwise. (Refer to Figure 8.)
2. Connect the other end of inlet pipe to the inlet
valve at the backside of washing machine and
fasten the pipe tightly clockwise.
NOTE:
After connection, if there is any leakage from
the hose, repeat the above steps to connect inlet pipe.
If tap is square or too big, then standard tap must be
changed to allow proper fitting.
DRAIN SYSTEM OPTIONS
Standpipe Drain System
Wall (Figure 9) or Floor (Figure 10)
The standpipe drain requires a
minimum diameter standpipe of
2" (50 mm). The minimum flow
capacity must be no less than 17
gallons (64 L) per minute.
The top of the standpipe must be
at least 23" (60 cm) high and no
higher than 39" (100 cm) from the
bottom of the washer.
Figure 5
Transport Hole Plugs (4)
2" (50 mm)
Figure 9
minimum
23" (600 mm)
maximum
39" (1000 mm)
13
Figure 6
Figure 7
Hot Cold
Figure 8
Figure 10