Initial Use; Usage - Beurer BY 52 Instrucciones Para El Uso

6. Initial use

1. Before use, ensure that the device and accessories (including mains cable) do not have any visible damage.
2. Place the device on a firm, even surface.
3. Connect the mains plug to the socket. The power LED lights up. The device is ready for use.

7. Usage

Warming up baby food/drinks and keeping them warm:
1. Place the lifter in the baby food warmer and place the bottle or jar in the lifter.
2. Fill the container with sufficient water depending on the size of the jar. Ensure that the water does not overflow.
Starting the warming process:
1. Press button followed by the rapid heat-up button
The warming time that is currently set now flashes on the display. On first use, the default setting of 15 mi-
nutes is displayed. If the device remains plugged in after the first use, it shows the last entered warming time
when subsequently used.
2. Enter the warming time (3 - 18 minutes). To do so, press the
desired warming time. The time is entered in minute increments; after "18", the display begins again at "3".
The warming time is dependent on the initial temperature, the type and quantity of food/drink, the
container material (glass/plastic) and the temperature of the water used to fill the device. The follow-
ing table offers a guide to selecting the warming time for food/drinks to be warmed to 37°C.
100 ml milk/chilled
250 ml milk/chilled
190 g puréed food/room temperature
3. Press the rapid heat-up button
The display now continuously shows the remaining warming time. The display starts to flash one minute
before the end of the warming process. The warming process stops once the pre-specified warming time has
elapsed. The heat LED and the display go out.
Starting the warming process without prior warming:
1. Press the button to switch the device on. The current temperature is shown on the display. The default
setting is 37 °C.
2. To enter the temperature, press the
keeping the food/drink warm (between 35 °C and 85 °C). The temperature increases in the steps 37, 38, 40,
45, 50, 60, 70, 80 until the display reaches "85" and then begins again at 35 °C.
3. Now press the
Ending the warming/keeping warm process:
1. Press the button for 2 seconds.
The display and the heater are switched off.
2. Remove the bottle/jar using the lifter.
3. Unplug the mains cable after each usage, pour all the water out and dry the device with a cloth.
again to start the warming process.
button repeatedly until you have reached the desired temperature for
button again to start the keeping warm process.
.
button repeatedly until you have reached the
Duration
~ 8 min.
~ 14 min.
~ 8 min.
12