Operation - Amcor NanoMax CF14000E Manual Del Propietário

5
1. ON/OFF
Press the / -button to switch the unit on or off.
ON OFF
2. Setting the Timer
Press the button, which will start the timer counter function.
TIMER
Each press of the timer button will advance the timer setting by 1 hour, for setting 1-12
hours. If you pass the desired hour setting, you must advance the numbers completely
through 12, to start timer count from 1. When set, the
When the set hours have elapsed, the unit will turn off automatically.
The display will show the hour(s) remaining when you press the
By pressing the button but without turning the unit on, you can pre-set in how
TIMER
many hour(s) the unit will switch on automatically.
3. Setting the Operating Mode
Select the required operating mode:
In mode the unit will select cooling or fan depending on the ambient temperature.
AUTO
4. Fan Speed
Select the fan speed, the corresponding
5. Increase UP or DOWN
When the unit is ON, the display
Press button UP or DOWN to see the current set temperature and adjust if necessary,
in the range of 62ºF to 90ºF. After 8 seconds, the room temperature will be displayed.
Warning lights COMPRESSOR and WATER FULL
When the water container is full, the unit automatically stops, the warning light
will fl ash to signal that the container must be emptied (see page 9, "Emptying The Water
Container").
When the unit is cooling, the compressor light will be on. If this light is off further cooling
is not needed at this time, or the compressor may be de-icing its coils.
The fan can still be on.

Operation

1
MODE
3
, , or
COOL FAN AUTO
will lit:
LED LOW
always shows the room temperature.
7
2
4
will light up.
TIMER LED
button.
TIMER
. The corresponding
LED
or .
HIGH
will lit.
WATER FULL