Juicing Tips; Care And Cleaning - BLACK&DECKER Home JE2050 Libro De Uso Y Cuidado

4. Place the cover on top of the pulp separator with feeder in
place (H).
H
5. Lock the locking latches by pressing down the cover as you fit the
tab at the top of each latch into the groove on each side of the
cover. Press the bottom of each latch until you hear it click into
place (J).
Important: The unit will not operate until the locking latches are
J OFF
LOW
HI
locked.
6. Place the juice cup under the juice spout (K).
7. Cut food into pieces to fit the food chute.
8. Plug unit into an C outlet. Turn the unit on by turning the
control to the LOW or HIGH speed position.
K
9. Place food in the food chute and press lightly with feeder.
10. Every time the pulp container is almost full, turn OFF and unplug the unit,
empty the pulp container and clean the cutter/strainer before you start juicing
again.
Caution: The cutter/strainer teeth are very sharp. Handle carefully.
11. When juicing is completed, turn off unit and unplug from outlet.
FOOD TR Y
1. Follow steps 1-3 in the HOW TO SSEMBLE ND USE section.
2. Place the cover on top of the pulp separator.
3. Insert food tray through the food chute and place on top of the
cover (L).
L
4. Insert feeder through the food chute on the food tray (M).
Note: Use the food tray to hold small fruits, such as berries, grapes,
mixed fruit pieces or mixed vegetable pieces as you process them
through the food chute.
5. Follow steps 5-11 in the HOW TO SSEMBLE ND USE section.
M
5

JUICING TIPS

When juicing carrots, do not overfill the food chute. Place carrots one by
one and use gentle pressure.
Juicing avocados or bananas will produce a puree rather than a juice.
When juicing large quantities of fruits and vegetables, stop and empty the
pulp container as it begins to get full and clean the cutter/strainer before
you start juicing again.

Care and Cleaning

This product contains no user serviceable parts. Refer service to qualified service
personnel.
TO CLE N THE UNIT
lways clean all parts after every use to prolong the life of the unit.
1. Turn unit OFF and unplug from electric outlet.
2. Disassemble all parts. See HOW TO DIS SSEMBLE section.
3. Wash the feeder, food chute, cover, cutter/strainer, pulp separator, juice spout,
juice cup and pulp container in warm sudsy water or in the dishwasher (top rack
only).
Caution: The cutter/strainer teeth are very sharp. Handle carefully.
4. Wipe the base with a damp cloth or sponge. Never immerse the unit in water.
Note: Over time, parts may change color (especially from juicing carrots or beets).
TO STORE THE UNIT
Fold the cable into the cord storage compartment on the side of the
unit (N).
N
6