ZIV 6IRV Manual De Instrucciones página 540

DNP Port 1 Port 2 and Port 3 Configuration
Number of Zeros

Number of zeros before the message.
Max Retries

Number of retries of the Physical Layer after collision detection.
Min Retry Time

Minimum time to retry of the Physical Layer after collision detection.
Max Retry Time

Maximum time to retry of the Physical Layer after collision detection.
Collision Type

Port 1:
NO
based on detection of transmitted data (monitoring all data transmitted on the
ECHO
link).
Port 2:
NO
based on detection of transmitted data (monitoring all data transmitted on the
ECHO
link.
DCD (Data Carrier Detect )
If the device prepares to transmit and finds the link busy, it waits until is no longer busy,
and then waits a backoff_time as follows:
backoff_time = Min Retry Time + random(Max Retry Time - Max Retry Time )
and transmit. If the device has a collision in transmission the device tries again ,up to a
configurable number of retries (
Wait N Bytes 485

Number of wait bytes between Reception and transmission Use Port 2 Operate Mode RS-
485
.
Atención © ZIV Aplicaciones y Tecnología, S.A. Zamudio 2004
Este documento contiene información confidencial propiedad de ZIV S.A. Cualquier forma de reproducción o
divulgación está absolutamente prohibida y puede ser causa de severas medidas legales.
DNP 3.0 : Device Profiles Document
(Advice Time) :
(N1 Retries) :
(Fixed_delay) :
:
:
based on detecting out-of-band carrier.
Max Retries
:
61 of 84
Page
) if has news collision.