Work Pro W CMU 100 Manual Del Usuario página 5

CMU 100
USER MANUAL
VERSION 1.3
12. TAPE OUT. This unbalanced output allows to send the meeting mix to a record device.
13. GROUP 1,2. These jacks connect with the chairman unit and delegates units. There
are two connecting channels. Each channel can connect with 35 units, therefore, it
could connect up to 70 units.
14. AC power input jack. Use the included IEC cable, plugging in a suitable AC outlet.
WMC 10D
Each delegate microphone is equipped with a loudspeaker and a cardioid backplate electret
microphone. To prevent acoustic feedback, the loudspeaker is switched OFF while the
microphone is in use. A red LED located in the microphone indicates to other participants
when the microphone is active. Up to 70 delegate units can be connected in a single system
in two loop-through-wired groups of 35.
WMC 10C
The chairman unit has the same functions and appearance as a delegate unit but it includes
a microphone over-ride button (PRIORITY). This button switches the delegate microphones to
OFF.
1. Mic capsule. To pick up voice of the speaker and send it to the system.
2. Mic light. To indicate the working condition of the microphone. Lit: Active.
3. Microphone button. To tun on/off the microphone.
4. Loudspeaker volume control (+) It increases the volume.
5. Loudspeaker volume control (-). It reduces the volume.
6. Loudspeaker.
7. Earphone jack 3.5 mm
8. Priority. (Only in WMC 10C). It allows the chairman to cut off the rest of delegate
units.
CONFERENCE SYSTEM www.workpro.es
4