Aquavitro element M Manual De Instrucciones página 11

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 19
5.
Put the Check Valve Ball (N) into the
Support Base (A) hole as shown in
Figure 2.
6.
Position the Pump (K) over the Support
Base (A) hole as shown in Figure 2.
7.
Turn the compression ring of the Pump
(K) clockwise to secure it onto the Support
Base (A).
8.
Position the By-pass Valve (M) over
the Support Base (A) hole as shown in
Figure 2.
Installation
The design of the element™ M Reactor offers various positioning options to optimize space by
rotating the Drain Spillway (J).
While the element™ M Reactor is not affected by changes in water level, it is necessary to
maintain a level of at least the ~MIN~ waterline mark on the Reactor Column (E).
1.
Place the element™ M Reactor inside of the aquarium system's sump in an accessible and
convenient position for regular maintenance and cleaning and also preferably near where
water comes into the sump from the aquarium.
2.
Make certain that the aquarium's sump is at its appropriate water level first.
3.
Orient the Drain Spillway (J) such that it flows away from the Pump (K).
Filling the Reactor Chamber
1.
To prepare and fill the Reactor Chamber (F), remove the Reactor Column Cover (H) by
releasing the Locking Ring (B2) and lifting off the cover.
2.
Remove the Reactor Chamber (F) from the Reactor Column (E) by pulling up on the
Threaded Rod (I).
9.
Turn the compression ring of the By-pass
Valve (M) clockwise to secure it onto the
Support Base (A).
10. Put the Drain Spillway (J) onto the top of
the Reactor Column Cover (H).
11. Slip the Filter Sock (L) through the Drain
Spillway (J).
11

Publicidad

Tabla de contenido
loading

Productos relacionados para Aquavitro element M

Tabla de contenido