Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Place the shelf into the tower by inserting the pins into the tower grooves.
5.
Create a shoe shelf by inserting the shelf upside down with the back one
groove higher than the front.
Creating Adjustable Shelves
Put your excess cuts back into your closet. Any material greater than 24 in.
wide can be used as an additional shelf.
Cut excess lengths to 24 in. wide to use as tower shelves & place where
ever you choose.
In an 8 ft. closet configuration your 4 ft. of excess shelving can create 2
additional adjustable shelves.
1.
Measure required dimension, mark & cut shelf.
2.
Place shelf end bracket onto shelf.
3.
Using the lower hole location on the bracket, drill a pilot hole using a 1/8 in.
drill bit.
4.
Remove the shelf end bracket.
5.
Re-drill hole 1 - 1 1/4 in. deep using a 1/4 in. drill bit.
6.
Repeat steps for each shelf end.
7.
Insert shelf pin into holes at each end.
STEP 9 - Final Touches
1.
Insert mushroom caps into all angle brackets.
2.
Touch up scratches & cut ends with stain pen provided.
10
Publicidad
Tabla de contenido
