Howto Stop Your Pressurewasher; Howto Useaccessory Tray - Craftsman 580.752541 Instrucciones De Uso

,& WARNING Exhaust heat/gases could ignite
combustibles, structures or damage fuel
causing a fire, resulting death,
tank in
serious injury and/or property damage.
Contact with muffler area could cause burns resulting in
serious injury.
* DO NOTtouch hot parts and AVOID hot exhaust gases.
* Allow equipment to cool before touching.
* Keepat least 5 feet (152 cm) of clearanceon all sides of
pressure washer including overhead.
* It is a violation of California Public Resource Code,Section
4442, to use or operate the engine on any forest-covered,
brush-covered, or grass-covered land unless the exhaust
system is equipped with a spark arrester, as defined in Section
4442, maintained in effective working order. Other states or
federal jurisdictions may havesimilar laws.
Contact the original equipment manufacturer, retailer, or dealer
to obtain a spark arrester designed for the exhaust system
installed on this engine.
* Replacement parts must be the sameand installed in the same
position as the original parts.
Howto Stop Your PressureWasher
1. Releasespray gun trigger and let engine idle for two
minutes.
2. Move throttle to SLOW position, then STOPposition.
3. Rotate fuel shut-off valve to "Off" position.
_1_ WARNING Fueland its vapors are extremely flammable
and explosivewhich could cause burns,
fire or explosion resulting in death,
serious injury and/or property damage.
• DONOTstopenginebymovingchokeleverto "Cheke"position.
4. ALWAYS point spray gun in a safe direction, push red
button and squeezespray gun trigger to releaseretained
high water pressure.
,& WARNING The high pressure stream of water that
this equipment produces could cut through skin
and its underlying tissues, resulting in serious
injury and possible amputation.
Spray gun traps high water pressure, even when engine is
stopped and water is disconnected, which could result in
serious injury.
* Keephigh pressure hoseconnected to pumpand spraygun
whilesystemis pressurized.
* ALWAYSpointspraygun in safedirection,pressred button
andsqueeze sprayguntriggerto release highpressure, e very
time you stop engine.
Howto UseAccessory Tray
The unit is equipped with an accessory tray with places to
store your spray gun and nozzle extension. There is also a
hook at the front of the accessory tray to hold your high
pressure hose.
NOTICE The extra hole in the tray is for storing a utility
brush. The extra clip in the tray is for storing a turbo nozzle.
The brush and turbo nozzle are NOT included with your
pressure washer. You can buy these items as optional
accessories.
1. Place nozzle extension and selector nozzlethrough hole
on accessorytray, as shown.
\
.
3.
4.
C I
Place selector nozzlethrough hole on accessory tray, as
shown.
Place spray gun through hole on accessory tray on right
side of unit.
Hang high pressure hose on hook attached to accessory
tray on front of tray as shown.
14