Bernzomatic JT850 Manual De Instrucciones página 2

• Leak test connection to cylinder before use. Do not check for gas leaks with a match or open flame. Apply soapy water
at cylinder connection. If bubbles appear disconnect cylinder.
• Do not use a leaking, damaged or malfunctioning torch. If torch is leaking, contact manufacturer or retailer.
• Do not attempt to light with match or cigarette lighter. Keep hand away from tip.
• Ignite torch away from face, hands, clothing, or other flammable material.
• Do not use for space heating.
• Always use the torch with the cylinder in the upright position. If tilted toward the horizontal position liquid fuel will
reach the burn tip, generating a large yellow flame. Immediately return to the upright position and turn the knob off.
• Before heating a surface, check to make sure that heat will not be conducted to adjoining areas that may be
combustible or become pressurized when heated. During use, check adjoining areas frequently for unintended heating.
• Work only in well-ventilated areas. Avoid the fumes from fluxes, lead-based paint, and all metal heating operations. Be
careful to avoid fumes from plated and galvanized metal
• Ensure that torch is completely cool before storing. Always disconnect cylinder from torch for storage.
• Brick and concrete can crack and explode when subjected to high temperatures.
• Do not leave unattended.
• Be careful on bright sunny days or under windy conditions. Bright sunshine can make it difficult to see the flame, and
wind can carry the flame or sparks to unintended areas.
• Make sure grip does not cover air holes before using.
ASSEMBLY
1. Use only with propane or MAP-Pro™ gas cylinders.
2. Turn valve control knob fully clockwise to OFF position.
3. Hold cylinder upright, and screw it into the valve until it is fully seated and hand tight.
4. Leak test connection to cylinder before use. Do not check for gas leaks with a match or open flame. Apply soapy water
at cylinder connection. If bubbles appear disconnect cylinder.
5. Make sure the grip does not cover the air holes. If so, slide the grip away to expose the air holes prior to use.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
08/19/16