peerless-AV I-beam ECMU-01-I Manual De Instalación página 5

Tighten bolts (T) on sides of ceiling plate assembly
4
just until they touch the ceiling clamp.
Tighten hex nuts (Y) until they touch the sides of
ceiling plate assembly.
Y
T
Safety Cable Installation
Wrap the 5' wire rope (W) tightly around the beam
5
once as shown. Use two cable clips (X) to connect
the ends together as shown below.
Once cable clips have been attached, the excess
cable ends can be removed.
5 of 36
ISSUED: 06-22-10 SHEET #: 061-9055-7 07-08-15
X
W