Environmental Conditions; Maintenance And Cleaning - Mestra R-080071 Manual De Instrucciones

INTRODUCTION
R-080071 is a practical wax heater specially
designed for the professionals in the dental
prosthesis sector. It can melt a wide range of
waxes very quickly and to keep them in a liquid
state without altering their properties. The
selection of the set-point temperature is easy
and quick.
Read this manual carefully. It contains very
•
important information
installation, operation and maintenance of
the machine.
Store this manual in a suitable place for
•
further consultation.
Check the general state of the machine after
•
removing the packing.
Before connecting the unit, make sure the
•
voltage in the identification plate matches
the power source to be used. During the
installation all the safety requirements must
be observed and the instructions of the
manufacturer followed.
The manufacturer will not be liable for the
•
damage caused
grounding system.
Damage caused by incorrect installation or
•
operation of the machine will not be covered
by the warranty.
If in doubt, do not start the machine. Contact
•
a qualified and authorised technician.

ENVIRONMENTAL CONDITIONS

Indoors use.
•
Temperature: 5 ºC ~ 40 ºC.
•
Humidity: Min. 50 % ~ Max. 80 %.
•
Maximum voltage fluctuation: ±10%
•
nominal voltage.
Protection level: II.
•
INSTALLATION
Choose a flat, horizontal and firm surface to
•
place the unit, away from heat and vibration
sources, and from inflammable materials.
Connect the unit to a 230 V, 50/60 Hz power
•
source.
OPERATION
Place the wax particles you want to melt in
•
the tank (C). Close the lid of the unit (A) and
turn the main switch (D) on (green light).
about a safe
by an inappropriate
Press the [ºC / ºF] key to select Celsius or
•
Fahrenheit degrees (the display will show ºC
/ ºF).
Press the [S/C] key to programme the
•
temperature. The pilot (I) will light up. Select
the temperature by pressing the [? /? ] keys.
Press the [S/C] key to see the actual
•
temperature in the tank. The pilot (J) will light
up.
After about 10 minutes, the wax will be ready
•
to be used. The pilot light (H) will turn off
once the key-point temperature has been
reached.
Keep the lid (A) closed during the periods in
•
which you do not need to remove any wax.
You will prevent spilling the wax. Outside
particles and impurities will not enter and
contaminate the wax.
After finishing the operation disconnect the
•
heater by turning the main switch (D) off.
Handle the heater cautiously for several
minutes until it has cooled down completely.

MAINTENANCE AND CLEANING

In order to ensure a long working life and an
optimal operation we strongly recommend:
To clean the wax remains in the tank, lid and
•
cover periodically. To do it, you can use a
spatula. Make sure the wax heater has been
previously disconnected from the power
source.
To prevent spilling melted wax over the
•
cover of the machine. Be cautious when
handling the spatula.
TECHNICAL SPECIFICATIONS
of
Voltage:
Fuse:
Power:
Temperature:
Depth:
Width:
Height:
Weight:
English
AC 230 V, 50/60 Hz
4 A
120 W
50 ~ 120 ºC
122 ~ 248 ºF
114 mm
192 mm
70 mm
1130 gr