Bissell SpotClean 5207 Serie Manual Del Usuario página 7

Operations
Cleaning with the Deep Stain Tool
(select models)
1. Attach the Deep Stain Tool to the handheld
cleaning hose.
2. Plug in the unit and press the power button
beneath the handle to turn it on.
3. Set the tool directly on top of the carpet
before pulling the spray trigger to inject formula
deep into your carpet fibers. Always keep the
Deep Stain Tool in direct contact with carpeting
to avoid over-spraying.
4. Release the spray trigger and gently scrub
the stain.
5. To lift the stain away, apply downward
pressure on the tool and slowly pull it toward
you. Watch as powerful suction removes the
dirt and cleaning solution. Continue until no
more dirt can be removed.
6. As a final step, use "drying strokes" (by not
pressing the spray trigger) to remove as much
moisture as possible. Repeat this step as often
as necessary.
NOTE: Oxy Boost formula will continue to clean
oxidizable stains for 6-8 hours.
Cleaning with the 3-in-1 Stair Tool (select models)
This versatile 3-way tool sprays, scrubs, and
suctions up dirt and stains from the outer
curves, corner, and tread of carpet staircase.
1. Twist the tool head to desired setting to clean
carpeted stair. The downward facing edge is the
active cleaning mode.
a. Use the flat area to clean top of stairs
b. Use pointed edge to clean inside crevice
c. Use indented area to clean outer corner
(nose) of stairs
2. Ensure the tool spray tip is pointing
downward. Pressing trigger, slowly move the
tool back and forth over the soiled surface
keeping the tool in contact with the carpet.
3. Release trigger and move tool slowly over
the soiled area to suction up water and dirt.
4. Continue to clean the area until no more
dirt can be removed.
a. b.
1
FLAT
c.
2 3
CREVICE
NOSE
www.BISSELL.com
7