Assembling The Breast Pump - Hartig+Helling Milchpumpe BS 300 Manual De Instrucciones

Assembling the Breast Pump

Complete the following steps carefully to en­
sure that the breast pump can achieve the suc­
tion effect required.
Insert the valve (13) from below in the pump
housing.
Carefully screw the feeding bottle (12) clock­
wise on the thread of the pump housing (3) as
far as possible.
Insert the silicone membrane (4) in the
pump housing (3) as illustrated.
Set the lid (5) on the pump housing (3) as
illustrated.
Carefully screw the lid (5) clockwise on the
thread of the pump housing (3) as far as possi­
ble.
Fit the breast shield (2) in the pump hous­
ing (3) as illustrated.
Pay attention that the breast shield (2) is
fitted properly and fully against your
breast.
Connect the hose (6) to the vacuum con­
nection in the lid (5).
Connect the hose (6) to the vacuum con­
nection (22) in the pump unit.
16
The second vacuum connection is pro­
vided with a rubber plug. Do not remove
the rubber plug, otherwise the breast
pump cannot generate a vacuum.
Only use the second vacuum connection
if you want to express breast milk from
both breasts simultaneously, e.g. if you
are the mother of twins.
We recommend Accessory Kit BS301. Simply
contact our Service department.