Galaxy Innovations ST9195 Manual Del Usuario página 21

4.4 System Setup
4.4.2.3 Display Format
You can select Display Format according to your TV type.
"PAL", "NTSC", "SECAM", and "PAL & NTSC" modes are supported.
4.4.2.4 Display Size
1080i, 720p, 576p, 480p.
4.4.2.5 Deinterlacer
You can turn on/off the Deinterlacer.
If you set the deinterlacer value to ON, HDMI/YUV picture quality of SD channels will be improve.
but, channel change speed will be slower.
4.4.2.6 YUV Output
You can turn on/off TV Component output.
If you want to set the video mode for TV SCART(RGB), then turn off the YUV Output and change SCART Output to RGB.
4.4.2.7 SCART Output
You can set the video mode for the TV SCART output, by pressing OK key, then press   key on the remote control unit.
2 Video Output as RGV/CVBS are supported.
4.4.3 Option
Press MENU key in Normal Mode, then select System Setup menu, and select Option.
4.4.3.3 LNB Voltage
You can set LNB voltage by pressing OK key, then press   key on the remote control unit.
Supported voltage : 13/18V, 14/19V.
4.4.3.4 Recall List
If you set it "ON", you will be able to see the "Recall List" when you press RCL button.
If you set it "OFF", you can go back to the previous channel only.
Note
Recall list is the menu in which you can see the channels you watched past.
MANUAL_GI ST9195_9196_Eng_091127.indd 21
4.4.3.1 Channel Change
You can select the way of changing the channel by pressing OK key, then press
  key on the RCU.
Supported mode : Blank, Fade
4.4.3.2 LNB Power
You can set the LNB Power ON/OFF by pressing OK key, then press   key on
the RCU.
21
2009-11-28 1:59:50