Selecting Digital Channels - Audiovox FPE709 Manual Del Usuario

PDF created with FinePrint pdfFactory Pro trial version
5. Press the LEFT or RIGHT button to select CATV/Air selec-
tion for the antenna selection.
6. If you are using the indoor or outdoor antenna, select Air here.
Press the DOWN button and select "Auto Scan".
7. If you are using the cable system, select CATV. Press the
DOWN button to select "Auto Scan". Use LEFT or RIGHT
button to set the Cable System you desire, Auto should be
the correct setting for most cable systems. If you choose Air
for the antenna selection, the Cable System selection is
unavailable. Then press the DOWN button and select "Start
to Scan".
8. The TV will start scanning the channels and store the
channels found in TV's channel memory.
9. When the scan is complete, the number of channels will be
shown on the screen and the TV will tune to the first channel
found.
10. Use the same way to select "Auto Scan Add CH" to add
more channels to those scanned.
NOTE: Press MENU button to interrupt the channel scanning.
If the TV didn't find any channel, the Channel up and Down
buttons do not function.

Selecting Digital Channels

You can select specific digital TV stations using your remote control.
To select a digital station, enter the channel number followed by "-1".
For example, enter "11-1" for the digital channel 11. If available, the
digital channel appears.
Some digital stations provide multiple broadcasts on a single channel.
To access these directly, enter higher numbers after the channel
number. For example, "11-2" "11-3" etc. for digital broadcasts of chan-
nel 11. If available, these digital channels appear.
13
http://www.fineprint.com