Powering And Installation - Audiovox FPE709 Manual Del Usuario

PDF created with FinePrint pdfFactory Pro trial version

Powering and Installation

1. Powering the System Indoors (Refer to Figure 1)
Plug one end of the AC to DC adapter into the DC input jack on the
right side of the main unit, then plug the other end into the 100~240V
AC power receptacle.
2. Powering the System in a Car
Plug one end of the Automotive
Power adapter into the DC input
jack on the unit, then plug the other
end into the vehicle power outlet.
3. To Charge the Built-in Battery
Plug one end of the AC to DC adapter into the DC jack on the side
of the TV, then plug the other end into the 100~240V AC power
outlet, or plug one end of the automotive power adapter on the side
of the TV, then plug the other end into the vehicle power outlet, as
shown in Figure 1. Make sure that the TV is turned off, and the red
charge light turns on. Once fully charged, the LED indicator turns
off, then remove the AC to DC adapter wall plug or the automotive
power adapter.
NOTE: Your new battery must be charged a minimum of 8 hours
before the first usage. Each full recharge takes approxi-
mate five hours and one full charge can provide power to
the player for approximate 2.5 hours.
Figure 1
8
http://www.fineprint.com