Care And Maintenance - Russell Hobbs Fiesta Manual De Instrucciones

ASSEMBLY
A. Place the drip tray into the base
B. Fit the grill plate with the power inlet on the same side as the safety bar.
C. Plug the connector into the power inlet on the appliance.
PREHEAT
1. Wipe the grill plate with a little cooking oil or butter. Don't use low fat spread – it may burn on to the
grill.
2. Turn the temperature control fully anticlockwise.
3. Plug the connector into the power inlet on the appliance.
4. Put the plug into the power socket.
5. Set the temperature control to the required temperature.
6. The light will come on, then cycle on and off as the thermostat maintains the temperature.
7. Lay the food on the grill with a spatula or tongs, not fingers.
8. Wait till the food has cooked.
REMOVE THE FOOD
• Check it's cooked. If you're in doubt, cook it a bit more.
• Remove the cooked food with wooden or plastic tools.

CARE AND MAINTENANCE

1. Unplug the appliance and let it cool down before cleaning or storing away.
2. Pull the connector out of the power inlet.
3. Wipe all surfaces with a clean damp cloth.
4. Wash the drip tray in warm soapy water, or in the top rack of the dishwasher.
RECYCLING
W
To avoid environmental and health problems due to hazardous substances, appliances
and rechargeable and non-rechargeable batteries marked with one of these symbols
must not be disposed of with unsorted municipal waste. Always dispose of electrical
and electronic products and, where applicable, rechargeable and non-rechargeable
batteries, at an appropriate official recycling/collection point.
4