3M M1 Instrucciones página 2

Instructions
Loading Instructions:
Refer to Figures 1 and 2 and follow the steps
below to load tape roll.
1. Position M1 Applicator in a comfortable
working position.
2. Lift Hub Support Shaft from the Metal Bracket
Hooks (Figure 1).
3. First remove O-rings on either side of Tape
Hubs and then remove Tape Hubs (Figure 1).
4. Center new roll of tape on Hub Support Shaft.
5. Reversing above procedure, firmly press Tape
Hubs and O-Ring's securely against
Tape Roll. (O-Ring's firmly hold the Tape Roll
in place during the tape application process -
Figure 2).
6. Replace assembly on Metal Bracket Hooks
(Figure 2).
7. Pull tape roll to thread applicator (Figure 3).
Surface Preparation:
Surface to be taped must be clear of dust, dirt,
grease or other foreign materials.
Allow solvents or liquids used for cleaning to dry
thoroughly.
Lane Marking Applicator M1 - NA
Tape
Hub
Hub
Support
Shaft
O-Ring
Metal
Bracket
Hooks
Figure 1
Tape
Hub
O-Ring
Figure 2
Adhesive Side
Figure 3
2
O-Ring
Tape Roll
Applicator
Tape
Hub
O-Ring
Adhesive Side
Direction of
Application
2014 March