Briggs & Stratton GenAlert Manual De Instrucciones página 8

4.
5.
6
Change switch positions as desired. See
following table for switch settings
Switch #
FACTORY USE ONLY
1
Do not change
Pick Up Ring Count.
2 When you call your monitored location, should
the dialer pick up after 5 rings or 10 rings?
Call out frequency during an alarm. How often
3 should the dialer call the pre-programmed
telephone number?
4 Alarm Input Position.
Properly position and replace the GenAlert's back
cover with the phone jack tab (A) over the phone
jack (B).
A
Function
6.
7.
B
OFF Position ON Position Default Position
N/A N/A
10 rings 5 rings
Every Every
15 minutes 2 hours
Normally Normally
Closed Open
Position Position
Plug one end of the telephone cord into GenAlert.
Plug the other end of the telephone cord into the
wall jack of the single line telephone.
Using generally accepted low voltage wiring
techniques, route the two-conductor wire from
GenAlert to the home generator control panel. If
necessary, extend wire lengths as described in
Extending Wire Lengths.
BRIGGSandSTRATTON.COM
OFF
ON
ON
ON