Low Flame Adjustment - Forza FRT304GN Manual De Instalación

Low Flame Adjustment

Lighting gas burners with a match is dangerous.
You should match light the burners only in an emergency. Light a match and
hold the flame near the burner you want to light. Wooden matches work best.
Push in and turn the control knob slowly.
Be sure you are turning the correct knob for the burner you are lighting.
NOTE: If the burner does not light within five seconds, turn the knob off and wait one minute before trying again.
If you attempt to measure the inner cone of the flame, please use caution.
Burns could result.
This appliance is shipped from the factory with low and medium flame settings adjusted.
If further adjustment is necessary, proceed as follows:
Adjustment for Burners with one or two flame rings:
1) Light burner and set control knob for low flame.
2) Remove control knob from valve stem.
3) Insert a slender, thin-blade screwdriver into the recess behind the control knob (Figure 2 for single flame and Figure 3
double flame) and engage blade with slot in adjusting screw. (A single flame; B double flame)
4) Turn adjusting screw to set flame size:
• Clockwise to reduce
• Counterclockwise to increase
5) Replace control knob when adjustment is completed.
30