BSA INVICTA CONTA Manual De Instalación página 7

Display during Operation
Operating mode
1:n = impulse
•
multiplication
Paragraph 5 – Setting the Maximum Flow
Programming
PROG
Pump Functions -­‐
Max flow rate
Max flow rate
P100%
P100%
-­‐
Max flow rate
F320s/m
Paragraph 6 – Password
Programming
P R O G
-­‐
-­‐
P a ss w o rd
* * **
P a ss w o rd
0 0 0 0 -­‐
Paragraph 7 – Flow Display Unit
Programming
EM00136204
Programmed
N:1 4
Stop P100%
Pump status
Empty = pump in start
•
Stop = pump stationary
•
Paus = pump in pause
•
-­‐
+
-­‐
-­‐
+
-­‐
-­‐
+
value of n
Current dosage value
Maximum dosage
•
percentage
This makes it possible to set the maximum flow offered by
the pump, and the programmed mode (% or frequency) is
used as the standard unit of measurement when displaying
the flow. Changes can be made by pressing the
then using the
Press to confirm and return to the main menu
By entering the password, you can enter the programming
menu and see all the set values. The password will be
requested whenever you seek to modify them.
The flashing line indicates the number than can be modified.
Use the key to select the number (from 1 to 9), and
the key to select the number to be modified. Confirm
by pressing the
password is eliminated.
This makes it possible to set the dosage unit of
measurement on the display.
Changes can be made by pressing the
using the
choosing between L/h (liters/hour), Gph (Gallons/hour), ml/m
(milliliters/minute) or standard (% or frequency, depending
on settings). Press
menu
rev. 2.1
Display during Setting (MODE key)
Operating mode
n:1 6
6 P100%
Effective
Current dosage value
value of "n"
•
The dosage % can be modified
by pressing the + or – keys at
the same time
Operation
keys to set the new value.
Operation
key. By setting "0000" (default), the
Operation
keys to set the unit of measurement,
to confirm and return to the main
Programmed value
•
Value of n
key,
key, then
5