Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Step 6
Install stopper and set eye position
Stopper can be remov-
able or non-removable
determined by position
of eye hole when later
inserting pivot rod.
■ Insert stopper
through flange
opening and
position eye hole.
When installed in removable position,
Removing stopper
move pivot rod to the up position (lift rod is in the down position
when later installed). Eye hole will slide over end of pivot rod.
Step 7
Attach pivot rod to drain body
■ Remove retaining nut and outer seat from pivot cavity.
■ Insert pivot rod
into pivot cavity
so pivot ball is
against inner seat
and rod passes
under
end
of
stopper according
to selected eye
hole position.
■ Slide outer seat over
pivot rod with curved end against pivot ball.
■ Fasten pivot rod to drain body with retaining nut.
Tighten using your fingers until ball is seated snug
and pivot rod can move around freely.
Step 8
Connect lift rod and adjust linkage
■ Insert lift rod through
hole on rear of water
spout.
■ Fasten end of pivot
rod with spring clip
through location hole
in clevis strap that is
best aligned to enable
lift rod also fasten to
end of clevis strap when
in the up position and
stopper is in the closed
position.
■ Insert lift rod into
end of clevis strap
and fasten with thumb
screw at location where
stopper can be easily
opened and closed.
If necessary, select another location hole in clevis strap and
re-adjust lift rod where fastened to clevis strap.
Step 9
Attach drain body to drain trap
stopper
ange
non
removable
removable
pivot rod
retaining nut
outer seat
pivot ball
inner seat
pivot cavity
lift rod
clevis strap
pivot rod
Step 10 Flush water supply lines
■ Thoroughly
supply lines to prevent
foreign matter, i.e.
copper chips, sand,
etc. from damaging
the sealing surface
inside control valves.
■ Remove
from end of faucet
water spout.
■ Turn hot and cold
faucet handles to full
valves and run long enough to flush supply lines thoroughly.
■ Turn faucet
Care of faucet finish
Clean finish area by using mild soap and water or non-abrasive
cleaner and then rinse immediately. A non-abrasive wax may
be used to preserve finish area.
Valve cartridge replacement
Step 1 Remove faucet handle
Loosen screw using a
Step 2 Remove collar
Remove collar by turning
counter clockwise.
Ensure not to use any tool
Note:
that could scratch finish without
taking protective measures.
Step 3 Remove cartridge
Using a wrench, turn hex nut
on cartridge counter clockwise.
Ensure valve assembly
Note:
under sink doesn't rotate while
turning nut.
Step 4 Insert new cartridge
Insert replacement cartridge
and then tighten hex nut.
thumb
screw
location
Step 5 Attach collar
holes
Screw collar onto fastener and
spring
tighten using your hand.
clip
Step 6 Attach faucet handle
■ Ensure cartridge spindle is
rotated to the
■ Attach handle in
as shown in illustration and
then tighten screw using a
inch Allen wrench.
Page 3
flush
remove
aerator
aerator
position and then open water supply
ON
, replace aerator and check for any leaks.
OFF
inch Allen wrench.
5/64
handle
screw
spindle
hot = cw
cold = ccw
cartridge
fastener
position.
OFF
location
OFF
5/64
collar
OFF
handles set
in the OFF
position
Publicidad
Tabla de contenido
