Installation Instructions - Symmons Carnaby SLW-6912-RP Instrucciones De Instalación Y Mantenimiento

Installation Instructions

If replacing an older faucet ensure water supply is
Caution:
turned before removing. Then turn faucet control valves
OFF
to relieve water pressure.
ON
Step 1 Attach control valves to sink
■ Thread flange nut about 2 inches down from threaded end
of valve body. Ensure larger diameter end is facing up.
■ Insert valve body
from underneath
sink up through
mounting hole.
Ensure valve with red
label (hot) is on the
left and blue (cold) is
on the right.
■ Place gasket over
valve body and
thread fastener
onto valve body
until stop is reached.
■ Tighten flange nut under sink to secure valve body.
■ Thread collar onto outer threads of fastener until against
surface of sink.
Step 2 Attach faucet handles
■ Turn valve spindles
to the position.
OFF
- left valve,
HOT
clockwise
- right valve,
COLD
counter clockwise
■ Attach handle to
valve spindle in
location and
OFF
tighten screw in
handle using a
5/64
inch Allen wrench.
Step 3 Attach faucet spout to sink
■ Unscrew tee and
remove washer and
nut from threaded end
of spout as shipped.
■ Insert end of spout
through base and
mounting hole.
Fasten from under
sink with washer and
nut.
■ Tighten nut while
ensuring spout and
base
are centered
over mounting hole
and flat edge of washer is facing rear of sink.
collar
fastener
gasket
ange nut
valve body
handles in
OFF position
valve spindle
screw
spout
base
washer
nut
tee
Step 4 Connect water supply lines
■ Apply pipe seal-
ant on male end
of both flex hoses
and thread into
sides of tee.
■ Thread center of
tee with flex hos-
es attached onto
end of spout.
This may
Note:
require about
4 inches of clear-
ance to rotate.
■ Attach loose end
of flex hoses
to valve outlets.
■ Plumb hot wa-
ter supply to left
valve inlet, cold
water to right inlet and fasten with coupling nuts.
■ Check for leaks if only replacing faucet and drain is already
installed by first turning faucet handles to the
and then turn water supply valves
Step 5 Fasten drain body to sink
■ Remove stopper, unscrew flange and remove flat rubber
washer from end of drain body as shipped.
■ Apply plumber's putty
around bottom
flange.
Washer included
Note:
should only be used
when plumbers putty
is not available.
■ Move friction washer,
beveled washer
flange nut down away
from end of drain body.
flange
■ Place
drain opening
screw drain body at
least 2-3 turns until
hand tight against
flange.
■ Position drain
so pivot cavity
facing rear of sink and
then slide beveled washer and friction washer up against sink.
■ Tighten flange nut up against friction washer to evenly
compress beveled washer while also ensuring flange is
centered in drain opening.
Take care not to over tighten flange nut.
Page 2
valve
body
valve
outlet
inlet
&
coupling
nut
tee
.
ON
of
PLUMBERS
PUTTY
and
into
and
ange nut
drain body
body
is
spout
ex hose
position
OFF
ange
beveled
washer
friction
washer
pivot
cavity