Status Display - AVIRE Memco Panachrome G3850 Guia De Instalacion

Speech Language
English
French
German
Italian
Spanish
Japanese
Key Sounds
Off
On
Advanced
Top Diode
Bottom Diode
Profile
Display
Access PIN
Serial Number
Firmware Ver.
Detector FW

Status Display:

The controller utilizes the LCD to show a coded status, so that common important settings can be observed at a glance.
This is also helpful for Avire service so they can get the configuration without going through menus.
The left hand side of the display shows status, the right hand side configuration
The format is as follows:
Digit Meaning
1 '2' indicates 2D trigger
2 '3' indicates 3D trigger
3 If untriggered, 1 -3 indicate approximate distance in cm (max 250cm)
4 'S' detectors are in energy saving mode
5 'T' 1 or more diodes timed out, 't' permanent trigger
6 ':' Separator between status and config
7 'v' if visible mode on
8 'N' visible normal, 'D' visible demo mode, 'E' visible external inputs, 'T' visible trigger
10mm
43mm
Status
Averages
Version
Tx
Rx
Defaulted to the same as menu language.
Keypad sounds OFF/ON
Sets which diode is the top (first) diode in the beam pattern
(1 to 6). This can be used to deactivate top diodes if they are
triggered by the door mechanism. Note that using this may not
be in compliance with EN81 requirements.
Sets which diode is bottom (last) diode in the beam pattern (12
to 48). Note that using this may not be in compliance with EN81
requirements.
G2510/G3510
G2540/G2510
Coded display of configuration and status - see below
Signal levels
Firmware version
Future use
Serial number of controller
Displays the firmware version.
Detector Firmware Version
Firmware version for each board in detector