Periodical Maintenance - Rebel BTR170 Manual De Instrucciones

Occasional maintenance (INSPECTION 2)
DEVICE MAINTENANCE MUST BE CARRIED OUT BY QUALIFIED PERSONNEL ONLY. OPERATORS
SHOULD NOT PERFORM DEVICE MAINTENANCE OR REPAIRS, UNLESS PROPERLY TRAINED.
Disconnect the battery before carrying out any maintenance operation or disassembly.
With a frequency of 500 000 cycles, the device shall be disassembled completely and the damaged
and worn out parts need to be replaced. It is also recommended to replace all the components
contained in the repair case.
The tool will advise the user when this term is reached (Capter Service / Next service).
Note that training can be proposed by the manufacturer for providing you the required knowledge
for maintaining the tool and ensuring its good performance and optimised lifetime.
Before proceeding with maintenance operations, please, refer to the dedicated maintenance
documentation. The tooling needed for these operations and the methods are described in this
documentation.
44